Network Camera & Live Cams Support

Step 1: hold camera shell with your two hands, and pull up the shell from camera base.

Step 2: Pull up camera shell from camera base.

Step 3: untied pins from lens base for both ends.

Step 4: unscrew lens’ board (there are two screws one on the top and another at bottom).

Step 5: Cut plastic cable ties (note: when you install them back, you have to use same size cable ties, Home Depot should have them).

Step 6: Unscrew another screw from lens support. (it is the second screw, there are two screws only, one at the top and another at the bottom).

Step 7: Take lens cover from lens board carefully.

Step 8: After flip lens board upside down, you need to install lens board back to pan and tilt base. Make sure shell with 4 clips and need to match the pins on the camera base.

Step 9: Set it up.

Step 10: DONE