Microseven Tech Support

Tech Support

Archive for January, 2015

Milestone XProtect works Microseven IP Cameras

without comments

Add Hardware manually, IP Address is camera IP address. Port is 8080, default username: admin, and default password: password. Driver is ONVIF Conformant Driver.

Here are two snapshot shown:

Microseven Milestone Xprotect

Microseven Milestone Xprotect

Microseven Milestone Xprotect

Microseven Milestone

Written by microseven

January 27th, 2015 at 12:04 am

Posted in How To

How to set up M7B57-WPS WiFi connected?

without comments

Step 1: Find camera IP address through camera locator software

Step 2: Go to browser to open camera page

Step 3: Unplug ethernet cable, now WiFi is connected.

Written by microseven

January 19th, 2015 at 11:03 pm

Posted in How To

Zoneminder v1.28 works with Microseven IP cameras

with 3 comments

Microseven IP cameras work with Zoneminder:
1. Configure Zoneminder to FFMPEG
2. Configure RTP/RTSP, and URL at rtsp://admin:password@ipaddress:554/11

Written by microseven

January 8th, 2015 at 2:52 am

Posted in How To

How to get snapshot after motion alert from my email?

with 2 comments

There are three steps to get motion alerts from email with snapshot.

1. Trigger motion in properties page. “Set motion detection area” in scene and save it.

2. Setup email properties in software.

3. To make sure DNS belongs to your ISP where you have installed camera.

Written by microseven

January 6th, 2015 at 2:23 am

Posted in How To